Website Closing Sale! 50% OFF! Promo Code BAKE50. All Sales Are Final. No cancelations, returns or refunds.

Taking Care of Your Airbrush


DISASSEMBLY OF AIRBRUSH

STEP 1: Pull air hose off the hose connector
STEP 2: Remove (7) handle by turning counter clockwise
STEP 3: Loosen (8) needle chuck nut.
STEP 4: Pull needle out. Be careful not to damage the point
STEP 5: Unscrew (11) spring guide
STEP 6: Remove (12) needle spring and (10) needle chucking guide respectively.
STEP 7: Remove (5) main lever by pulling then twisting and (6) auxiliary lever by twisting then pulling.
STEP 8: Remove (1) crown needle cap and (2) nozzle cap respectively.
STEP 9: Using the small flat wrench received with the airbrush, remove (3) nozzle. Note: the nozzle has two flat spots. Place the slot of the over these slots and turn counter clockwise.

CLEANING AND LUBRICATION
Using KOPYKAKE Airbrush Cleaner submerge all pans' except the needle, in a glass or metal pan for a few minutes then scrub with a small paint brush until all color has been removed. Clean especially the color cup (4) THE AIRBRUSH COLORING GOES IN THIS CUP. Make sure you have a good liquid flow out of where the nozzle connects. Use a Q-tip to scrub the walls and to reach into the color cup. Rinse the parts with hot water and dry thoroughly with a lint-free cloth. Clean the needle with airbrush cleaner and check the point to make sure there is no damage. Look at the point of the needle for a bend or hook. Using a white piece of paper and placing the needle on it and rolling it will make it easier to see if damage exists and needs to be replaced.

ASSEMBLY
STEP 1: Using the nozzle wrench, screw in then tighten the nozzle (3). Caution: do not apply excessive force when tightening the nozzle. 
STEP 2: Screw on the nozzle cap (2) and hand tighten.
STEP 3: Screw on crown cap (1) STEP 4: Hold the airbrush as show in the diagram to complete 
STEPS 4 and 5. Take auxiliary lever (6) and hold as shown in Diagram C. Insert inside opening, twist so that the hump is towards the back and let it rest against the back of the opening. 
STEP 5: Before you perform STEP 5, inspect main lever (5), Notice there is a thinner rounded section on the flat part under the round head. This side goes towards the back of the opening. Refer to Diagram B. Insert main lever (5) into opening and guide the two pins into the two channels located on the walls inside the opening. Move head back against the auxiliary lever (6) and hold there. Hold these parts (5) and (6) secure with your finger and go to 
STEP 6: Insert needle chucking guide (10) channel down into back of the airbrush. Slide needle spring (12) over needle chucking guide (10). Insert spring guide (11) over spring (12) screw in and tighten. This spring mechanism will push the main lever and auxiliary lever forward. 
STEP 7: Insert the needle through needle chucking guide (10) and slowly push all the way forward. Screw on the chucking nut and tighten securely.
STEP 8: Cover the back of the airbrush with handle (7).